Hi everyone.
I have a question about the TDS readings and the boarder line, is it 50 plus, so we are aiming below 50 ppm so as to be ok.
Reason I ask is because I am running low on water however the new tank I am putting in is 1520 liters which will come off of a roof that had over grown plant material that had composted, I have since removed and pressure washed this, and allowed a few rain falls to help remove anything that's there. But I am concerned about cement that's holding the tiles, and any other contaminates, how do I test for things such as this. The Old pool is a swimming that's loaded with rain water and plant material growing in it, has not been touched for years, but it's 9ft x 20ft x 7ft deep, only down side it's it's not local and at a relatives.
Source TDS GH No3
Green house tank 1 15ppm 0 10
Roof (New Tank) 40ppm 0 12.5
Old Pool 34ppm 0 10
Any advise welcome.
Noddy
I have a question about the TDS readings and the boarder line, is it 50 plus, so we are aiming below 50 ppm so as to be ok.
Reason I ask is because I am running low on water however the new tank I am putting in is 1520 liters which will come off of a roof that had over grown plant material that had composted, I have since removed and pressure washed this, and allowed a few rain falls to help remove anything that's there. But I am concerned about cement that's holding the tiles, and any other contaminates, how do I test for things such as this. The Old pool is a swimming that's loaded with rain water and plant material growing in it, has not been touched for years, but it's 9ft x 20ft x 7ft deep, only down side it's it's not local and at a relatives.
Source TDS GH No3
Green house tank 1 15ppm 0 10
Roof (New Tank) 40ppm 0 12.5
Old Pool 34ppm 0 10
Any advise welcome.
Noddy